2011 RAM Pickup
Mileage
178,445
Service Date
8/25/2025
Services Performed
- All systems code scan: Engine P0520
- Engine Oil Pressure Sensor Circuit P0463
- Fuel Level Sensor 1 Circuit High Door Module – Front Left (DMFL) B1D32-15
- Driver Mirror Heater Control – Circuit Short to Battery or Open – Active, Stored. B21A1-00
- ECU Reset/Recovery Occurred – – Stored. Door Module – Front Right (DMFR) B1D36-15
- Passenger Mirror Heater Control – Circuit Short to Battery or Open – Active, Stored. B21A1-00
- ECU Reset/Recovery Occurred – – Stored. Heat Ventilation A/C (HVAC) B1058-92
- Recirculation Door Control – Performance or Incorrect Operation – Stored. B11CB-92
- Main/Left Temperature Door 1 Control – Performance or Incorrect Operation – Stored. Radio B157B
- Satellite Region Mismatch – US/Canada – – Active Tire Pressure Monitor (TPM) C151D-00
- Tire Pressure Sensor Location Undetermined – – Stored. C1501-96
- Tire Pressure Sensor 1 – Component Internal Failure – Stored. C1504-96
- Tire Pressure Sensor 4 – Component Internal Failure – Stored. C1580-00
- Left/Right Side Tire Pressure Sensor Location Undetermined – – Stored. C1502-96
- Tire Pressure Sensor 2 – Component Internal Failure – Stored. C1503-96
- Tire Pressure Sensor 3 – Component Internal Failure – Stored. Wireless Control Module (WCM) B1A79
- Remote Start Antenna Circuit Open/Not Connected – – Stored OBDII Codes ($03) P0520
- Engine Oil Pressure Sensor/Switch "A" Circuit P0463
- Fuel Level Sensor "A" Circuit High OBDII Permanent Codes ($0A) P0520
- Engine Oil Pressure Sensor/Switch "A" Circuit Engine oil pressure signal is way off. With key on, engine off, the oil pressure is reading 93psi. No change when running. Voltage on EOP signal circuit is 4.57 all the time. Unplugged the voltage jumps to 5.0 as expected. When jumping signal ground to signal at the sensor connector the signal drops to 0 volts as expected. Needs EOP sensor replaced. Monitor the fuel tank level sensor signal on scan tool while driving. Found that there is an intermittent spike to 5.0V when driving around and letting fuel slosh over bumps. This is indicating an intermittent open circuit in the sending unit contacts in the fuel tank. Need to replace the sending unit/fuel pump assy.
- OIL PRESSURE SENDER OR SWITCH – Remove & Replace
- FUEL PUMP – Remove & Replace – 1500 w/o Skid Plate
- Fuel
- Smog inspection
- Certification fee
Christopher F. gave our service a 5 star review on 8/25/2025
