2007 Ford Pickup

  • 2007 Ford Pickup

    Ford Pickup
    Service Date
    Services Performed
    • Engine – Memory Codes P0340
    • Cam Position Sensor Circuit Fault P1000
    • OBDII System Checks Incomplete P1336
    • Crankshaft Position (CKP) And/Or Camshaft Position (CMP) Input Signal To The PCM Concerns Verified there is no signal from the CMP sensor. Flat line 5V output, no switching to 0V. Remove CMP from the synchronizer and found the sync has hit the CMP magnet and knocked it loose. Sync bushing worn out, causing excess play in shaft and contact occurred between shutter and CMP. Need to replace the synchronizer and CMP sensor. Need to remove heater hose pipe from the water pump to extract sync and to set up timing tool.
    • Change oil & filter. Top off all fluid levels. Check & adjust tire pressure. Visual inspection of hoses, belts, etc. Lube chassis.
    • CAMSHAFT SYNCHRONIZER – Remove & Replace – V6 – [Includes: Replace Camshaft Position Sensor.]
    • Hazardous waste disposal fee
    Art B. gave our service a 5 star review on 7/3/2024


Ray Frey Auto Center Inc
7696 Vickers St
San Diego, CA92111-1526
(858) 278-7077

We Service