2015 Subaru Forester
Mileage
41,437
Service Date
10/10/2023
Services Performed
- Full Systems Code Scan: Engine P0700
- Transmission Control System (MIL Request) U0122
- Lost Communication with Vehicle Dynamics Control Module Transmission U0122
- Lost Communication with Vehicle Dynamics Control Module Body Integration Unit U0122
- Lost Communication with Vehicle Dynamics Control Module Combination Meter U0122
- Lost Communication with Vehicle Dynamics Control Module U0122
- Lost Communication with Vehicle Dynamics Control Module Electric Power Steering U0122
- Lost Communication with Vehicle Dynamics Control Module EyeSight B2806
- Electronic Control Module Abnormal B2801
- Transmission Control Module Abnormal U0122
- Lost Communication with Vehicle Dynamics Control Module P00A8
- Refer to OEM repair information for code description P06A8
- Refer to OEM repair information for code description P01C1
- Refer to OEM repair information for code description P2201
- Refer to OEM repair information for code description B2806
- Electronic Control Module Abnormal B2801
- Transmission Control Module Abnormal U0122
- Lost Communication with Vehicle Dynamics Control Module P0200
- Refer to OEM repair information for code description Tire Pressure Monitor C2521
- Speed Abnormal OBDII Codes ($03) P0700
- Transmission Control System (MIL Request) U0122
- Lost Communication With Vehicle Dynamics Control Module OBDII Permanent Codes ($0A) P0700
- Transmission Control System (MIL Request) U0122
- Lost Communication With Vehicle Dynamics Control Module Scanner is unable to communicate with VDC(ABS) module. All codes point to this issue. Check CAN network resistance at the DLC, found 60 ohms which is the expected value. The ABS module and the PCM are the two modules with resistors in the CAN circuit. Unplugging the ABS module results in the expected 120 ohm CAN value, as each module has a 120 ohm resistor. Shorting the CAN circuit at the ABS connector results in zero ohms, so CAN circuit is normal. Load tested the powers and grounds at the ABS module, all normal. ABS module is faulty. Looks like dealer recommended all 4 wheel bearings. Road tested and verified some bearing noise. With vehicle running on lift found RF and LR bad. RR makes a very small amount of noise, and LF is silent. Recommend RF and LR first.
- ABS CONTROL MODULE – Remove & Replace – [Includes: Bleed System. Includes: Additional time for use of scan tool to perform this procedure.]
- WHEEL HUB – Remove & Replace – Front,One Side – [DOES NOT include wheel alignment.]
- WHEEL HUB – Remove & Replace – Rear,One Side
Sharon C. gave our service a 5 star review on 10/11/2023
