2018 Honda Accord
Mileage
91,568
Service Date
9/18/2024
Services Performed
- Confirm very long crank time. Zero throttle response, will only idle. Multiple warning indicators and messages are on for multiple systems. Full systems code scan: Engine – Permanent Codes P0107
- Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage P0335
- Crankshaft Position (CKP) Sensor No Signal P0122
- Throttle Position (TP) Sensor (A) Voltage Low P0222
- Throttle Position (TP) Sensor (B) Voltage Low P2122
- Accelerator Pedal Position (APP) Sensor (A) Voltage Low P0192
- Fuel Rail Pressure Sensor Circuit Low Voltage P0641
- Sensor Reference Voltage (A) Malfunction Antilock Brakes – Permanent Codes C0077-78
- Low Tire Air Pressure U0401-68
- ECM Failure Airbag (SRS) – Permanent Codes B0020-13
- Open Or Increased Resistance In The Left Side Airbag Inflator Electric Brake Booster – Permanent Codes U3003-16
- Brake Booster Control Unit Power Circuit ( + B ) Low Voltage Electric Power Steering – Permanent Codes U0416-68
- Vehicle Stability Assist System Malfunction Integrated Driver Support System – Permanent Codes U0401-68
- PCM (PGM – FI System) Malfunction C0051-54
- Steering Angle Neutral Position Learning Incomplete U0416-68
- VSA Brake Actuator Malfunction Tire Pressure Monitor – Permanent Codes C0077-78
- Low Tire Air Pressure U0401-68
- ECM Failure Body Electrical – All Body Electrical Codes B1C61
- Driver's Heater Current Abnormal Low B1C63
- Passenger's Heater Current Abnormal Low Data confirms multiple engine sensors at zero volts including APP "A" ("B" works normally), MAP sensor, TPS and FRP. P0641 indicates a failure of the 5 volt reference circuit "A" which supplies power to all sensors with current faults. Confirm no 5VREF at any of the sensors. Unplug all sensors on this circuit and found the reference voltage is normal. One by one plugged sensors back in while monitoring the voltage and found that when the MAP sensor was plugged in the voltage went to zero. Confirm the MAP sensor is shorted to ref ground internally, taking the reference voltage from PCM down to zero volts. Leaving MAP unplugged and clearing codes allows all systems to function normally. Need to replace MAP sensor. Also note the Maintenance Message is on and displays past due by 3,500 miles and is requesting services B1, 2 and 7. LOF sticker from Walmart shows over by 10,000 miles.
- Replace MAP sensor
- B1,2 and 7 are showing due on dashboard- Services recommended are -Air Filter -Cabin Filter -Brake Fluid Flush
- Change oil and filter. Replace with synthetic oil. Lube chassis, top off all fluid levels, adjust tire pressure. – Front tires 4/32 – Rear tires 5/32 – Front brakes approx 6mm remaining – Rear brakes approx 3mm remaining, brake pulsation. Recommend rear brake pads and re surface. – Rear tires cupping – will need tires soon
- Remove and Replace Air Filter
- Replace the cabin filter
- Flush brake system
- Install dealer pads.
- Machine rear rotors on vehicle
- Hazardous Waste Disposal Fee
Denise M. gave our service a 5 star review on 9/18/2024
