Change oil and filter. Replace with synthetic oil. Lube chassis, top off all fluid levels, adjust tire pressure. – Air filter dirty – Cabin filter dirty
Hazardous Waste Disposal Fee
Visual inspection through wheels: – Front brakes approximately 40% remaining – Rear brakes approximately 80% remaining
Shelly G. gave our service a 5 star review on 8/18/2023
Full systems code scan: Instrument Panel Cluster U0163-87
Lost Communication with Navigation Control Module Missing Message B1507-18
Turn Signal Light Circuit Current Below Threshold Front Recognition Camera (Front Lighting Control) U0235-87
Lost Communication With Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message Lane Control U0235-87
Lost Communication With Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message Pre-Collision U0235-87
Lost Communication With Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message Antilock Brakes – Current Codes C13AF
EPB System Malfunction Airbag – History Codes B1821
Open in Side Squib (D Seat Side) Circuit B1876
Open in Passenger Side Front Seat Cushion Squib Circuit U0154
Refer to OEM repair information for code description Door Motor Modules:Door Motor – Rear Left – History Codes B2312
Power Window Switch of Left Rear Side door Malfunction Door Motor Modules:Door Motor – Rear Right – History Codes B2312
Power Window Switch of Right Rear Side door Malfunction Body Control Module – History Codes B2321
Driver Door Motor ECU Communication Stop B1206
P/W Master Switch ECU Communication Stop U0155
Lost Communication With Instrument Panel Cluster (IPC) Control Module U0327
Software Incompatibility With Vehicle Security Control Module U0163
Lost Communication With Navigation Control Module U0120
Lost Communication With Starter / Generator Control Module U1117
Lost Communication With Accessory Gateway U0230
Lost Communication With Rear Gate Module U0126
Lost Communication With Steering Angle Sensor Module B2430
LED Headlight Left Hand B2431
LED Headlight Rear Hand B124B
Automatic High Beam System Blind Spot Monitor Master – History Codes C1AB4
Open in Outer Mirror Indicator (Master) Heating & Air Conditioning – HVAC History Codes B1476
A/C inverter load System malfunction Smart Key Access – History Codes U0155
Lost Communication With Instrument Panel Cluster (IPC) Control Module Navigation System – History Codes B15FE
XM Tuner Antenna Disconnected Electric Parking Brake – Current Codes C13A3
Open or Short Circuit in Lock Switch Circuit C13A4
Open or Short Circuit in Release Switch Circuit Tested cooling system for HC, none found. Radiator is full, topped tank to full cold mark. Inverter coolant level okay. Run engine in maintenance mode to test cooling system and monitor temp and fan speed command. Once hot, the fan speed command climbed to 100% and fan was inoperative. Temp continued to climb. Test fan electrical. Found good power to fan motor, but inconsistent ground. Ground would show normal on a low draw test light but would not drive a load like a light bulb. Trace ground circuit fault to loose ground bolt under the air cleaner assy. Based on all other fault codes that were stored in multiple systems as well as visible indicators, suspect vehicle just had collision repair performed, and bolt was accidentally left loose. After tightening ground the cooling system operation was normal. Triangle light was on at the time due to the A/C inverter load System malfunction fault code in the HVAC system. Loss of cooling fan operation caused A/C pressure got too high causing excess load on compressor.
John R. gave our service a 5 star review on 7/5/2023